Course 2, Mechanical Engineering, at MIT has a requirement that all seniors need to complete a thesis project alongside a faculty member as a degree requirement. Some students continue research they were already doing previously, and some come up with their own projects. For my thesis, I wanted to construct a DIY laser cutter, inspired by this project:
http://builders.reprap.org/2010/08/selective-laser-sintering-part-8.html
One of the first things I did was to get a laser diode up and running. A laser diode is a small electronic component that emits laser light. A laser diode is much less powerful than traditional lasers used on laser cutting machines, but likewise much less expensive. Here is picture of what the laser diodes I am using look like:
First, I had to build a circuit that would be able to power the diode without breaking it. Using some advice from Peter, who built the laser in the project mentioned above, I got the laser up and running. But how could I simulate the motions made by a laser cutter? I know, LEGOs!
So I built a test rig out of some LEGOs left over from 2.670, a LEGO robotics competition that’s is held during MIT’s IAP (Independent Activities Period in between the fall and spring semester). The test rig uses 2 servo motors, one to move the laser up and down, and the other to move the laser in a linear path. Here you can check out a video of a slightly older version the LEGO test rig burning some plastic!
More to come as the project develops!
-Josh

